FCC WARNING STATEMENT
This device complies with part 15 of the FCC Rules. Operation is
subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including
interference that may cause undesired operation.
Any changes or modifications (including the antennas) to this
device that are not expressly approved by the manufacturer may
void the user's authority to operate the equipment.
FCC RF Radiation Exposure Statement: This equipment
complies with FCC RF Radiation exposure limits set forth for an
uncontrolled environment.
This device and its antenna must not be co-located or operating
in conjunction with any other antenna or transmitter.
Note: This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against
harmful interference in a residential installation This
equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications, However, there
is no guarantee that interference will not occur in a
particular installation. If this equipment does cause
harmful interference to radio or television reception,
which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
26
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and
receiver.
- Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV
technician for help.
Modifications not expressly approved by the
manufacturer could void your authority to operate the
equipment under FCC rules.
27