Dogtra iQ PLUS Manuel Du Propriétaire page 11

Follow the steps below to charge your system:
1. Open the rubber plugs on the battery
charging receptacles and plug in the
charging cable.
2. Plug the charger into a 120-volt wall
outlet or, if using the auto charger,
plug into a cigarette lighter only for
lithium polymer batteries (use a 220
volt European charger for Europe).
All indicator lights should glow red
when properly charging and the unit
will automatically shut off during the
charging process. You will need to turn
the unit on again before use once the
unit is fully charged and unplugged
from the battery cable.
18
3. The lithium polymer battery is fully
charged within 2 hours. The lights will
stay red during the charging process
and turn green once the unit is fully
charged.
4. After charging, cover the battery
charging receptacles with the rubber
plugs.
8. CODE SETTING
Coding the 1st Dog Position:
1. Set the Rheostat Dial to 0 and place
the toggle switch in "I" position.
2. With the receiver turned off, place the
red dot on the back of the transmitter
to the red dot on the receiver. Hold
the two red dots together for about
5 seconds until the green LED blinks
rapidly on the receiver.
3. While the green LED is rapidly blinking
on the receiver, separate the two
devices and press the two top buttons
(Nick & Constant) simultaneously on
the transmitter. The LED light on the
receiver will blink every 4 seconds
when coding is complete.
Coding the 2nd Dog Position:
1. Set the Rheostat Dial to 0 and place
the toggle switch in "II" position.
2. With the receiver turned off, place the
red dot on the back of the transmitter
to the red dot on the receiver. Hold
the two red dots together for about
5 seconds until the green LED blinks
rapidly on the receiver.
3. While the green LED is rapidly blinking
on the receiver, separate the two
devices and press the two top buttons
(Nick & Constant) simultaneously on
the transmitter. The LED light on the
receiver will blink every 4 seconds
when coding is complete.
19