Publicité
Les langues disponibles
Les langues disponibles
Before use
CAUTION
Insert the dustbin before using POWERbot.
Be careful with the followings for proper
automatic recharging.
– Always turn on the power of the docking
station.
– Install the docking station where POWERbot
can easily find.
– Do not leave any object in front of the docking
station.
When installing the docking station, do not
leave the cord carelessly on the floor since
POWERbot may get tangled by it.
Do not use POWERbot on black colored
floors.
– The POWERbot may not be able to operate
normally.
Do not pick up POWERbot by the dustbin
holder.
Do not place any objects within 2 ft (0.5 m)
to both sides and 4 ft (1 m) to the front of the
docking station.
Make sure the docking station's charging
contact is not damaged or have any foreign
matters on it.
Do not install the docking station in an area
with a dark floor.
– If the floor around the docking station is dark,
recharging is hindered.
Move any obstacles that may disturb
POWERbot's movement (such as children's
indoor swing or slides) before cleaning.
CAUTION
Using POWERbot on thick carpet may
damage both POWERbot and the carpet.
– The POWERbot cannot pass over carpet that is
thicker than 0.4 in (1 cm).
Do not use POWERbot on tables or other
high surfaces.
– There is a risk of damage if it falls.
The POWERbot may bump into chair, desk
legs therefore move them away for faster and
efficient cleaning.
When POWERbot is operating, do not lift it up
or carry it to another area.
Do not hold by driving wheels of POWERbot
when carrying it to another area.
Do not put any objects on top of POWERbot
since it may cause malfunction.
Remove any large papers or plastic bags
immediately when using POWERbot since
they may block the intake.
Do not aim the red pointer directly at people
or animals.
CAUTION
Prevent any damage to POWERbot by
complying with the following.
– Do not clean POWERbot by spraying water
directly onto it or use benzene, thinner, acetone
or alcohol to clean it.
Do not disassemble or repair POWERbot.
This should only be done by a certified
repairman.
Always keep the obstacle sensor and cliff
sensor clean.
– If foreign matter accumulates, sensors may
malfunction.
ENGLISH-09
In use
Cleaning and
maintenance
Publicité
