Publicité
or, as an alternative, a system separator as per
EN 12729 Type BA. Water flowing through a sys-
tem separator is considered non-drinkable.
Note: Impurities in the water can damage the
high-pressure pump and accessories. For pro-
tection, the use of the KÄRCHER water filter (op-
tional accessory, order no. 4.730-059) is
recommended.
Water supply from mains
Observe regulations of water supplier.
For connection values, see type plate/technical
data.
Use a fibre-reinforced water hose (not in-
cluded) with a standard coupling. (Minimum
diameter 1/2 inch (13 mm), minimum length
7.5 m).
Screw the coupling unit (supplied) to the wa-
ter connection on the appliance.
Push the water supply hose onto the cou-
pling unit, then connect it to the water supply.
Start up
Caution
Never operate the high-pressure cleaner when
the tap is turned off as dry running will damage
the high-pressure pump.
Connect the high pressure hose to the high
pressure connection of the appliance.
Push the spray lance into the trigger gun and
fasten it by turning it through 90°.
Completely open the water tap.
Insert the mains plug into the socket.
Turn on the appliance "I/ON".
Operation
Danger
The trigger gun is subjected to a recoil force
when the water jet is discharged. Make sure that
you have a firm footing and are also holding the
trigger gun and spray lance firmly.
Unlock the lever on the trigger gun.
Pull on the lever of the trigger gun; the device
will switch on.
Note: Release the lever of the trigger gun; the
device will switch off again. High pressure re-
mains in the system.
Spray lance with Dirtblaster
For particularly dirty items or areas.
Not suitable for use with detergents.
Spray lance with high pressure nozzle
For normal cleaning tasks.
Not suitable for use with detergents.
12
English
Working with detergent
Please use exclusively KÄRCHER detergents
and care products to carry out the respective
cleaning task, as these were specifically devel-
opped for your appliance. The use of other deter-
gents and care products may lead to premature
wear and can invalidate your warranty claims.
Please obtain information at your local dealer or
request information directly from KÄRCHER.
Detach spray lance from the trigger gun.
Work only with the trigger gun.
Suspend end of detergent suction hose in a
container filled with detergent.
Recommended cleaning method
Spray the detergent sparingly on the dry sur-
face and allow it to react, but not to dry.
Spray off loosened dirt with the high-pres-
sure jet.
Interrupting operation
Release the lever on the trigger gun.
Lock the lever on the trigger gun.
During longer breaks (more than 5 minutes),
also turn the appliance off using the "0/OFF"
switch.
Insert the trigger gun in its holder.
Finish operation
Caution
Only separate the high-pressure hose from the
trigger gun or the appliance while there is no
pressure in the system.
After working with detergent, suspend deter-
gent suction hose in a container filled with
clear water, switch the appliance on for
around 1 minute once the spray lance has
been removed and rinse until water runs
clear.
Release the lever on the trigger gun.
Turn off the appliance "0/OFF".
Turn off tap.
Detach the appliance from the water supply.
Press the lever on the trigger gun to release
any remaining pressure in the system.
Lock the lever on the trigger gun.
Pull out the mains plug.
Roll up the power cord and loop it e.g. round
the handle.
Engage the spray lance in its compartment.
Publicité
