Publicité
Les langues disponibles
Les langues disponibles
ENGLISH
1. PARTS AND COMPONENTS
Fig. 1
Freezer compartment
Temperature knob
Shelf
Drawer cover
Crisper drawer
Door shelf
Light switch
Door shelf
Note:
The graphics in this manual are schematic representations and may not exactly match the
appliance.
2. BEFORE USE
-
This appliance is packaged in a way as to protect it during transport. Take the appliance
out of its box and remove all packaging materials. You can keep the original box and other
packaging elements in a safe place. This will help you prevent damage to the appliance
when transporting it in the future. In case the original packaging is disposed of, make sure
all packaging materials are recycled accordingly.
-
Make sure all parts and components are included and in good conditions. If there is any
piece missing or in bad conditions, contact the official Cecotec Technical Support Service
immediately.
3. INSTALLATION
Installation
Place the refrigerator on a completely flat surface. Leave 5~10 cm between each side of
the appliance and the wall, and 30 cm between the top of the appliance and the ceiling.
Choose a place that is not exposed to sunlight, high temperatures, or humidity, as moisture
can cause stains.
Remove the bottom panel before installation.
The appliance can be adjusted via its two front support feet. You can raise the appliance by
turning them clockwise.
Choose a solid and flat surface for installation. Improper levelling and installation can
cause noise and vibrations:
50
BOLERO COOLMARKET 2D ORIGIN 86 E
Noise may increase if the floor is not solid.
You can place a sheet under the appliance to solve the heat-emission problem if you need
to place it on a carpet.
Make sure the adjustable feet are securely on the floor and adjust the tilt of the appliance
slightly backwards to keep the doors securely closed.
Installing the handle
Fig. 2 key:
Handle
Handle trim
Screws
Socket spanner
Remove the accessories from the packing bags: the handle, the handle trim, and the three
screws.
Take a socket spanner.
Make sure the three screw holes of the handle screws are aligned with those of the door,
then screw them in respectively. It is preferable to screw on the right side (Fig. 3).
Install the handle trim on the handle (Fig. 4):
1.- First, fit the handle on the right-hand side.
2.- Fit the handle on the left-hand side.
3.- Firmly fit the central part of the handle until you hear a "click". This means that the
handle is installed correctly.
4. OPERATION
The temperature of the refrigerator can be manually controlled via the knob. However, the
-
number displayed on the knob isn't directly indicative of interior temperature.
-
The higher the number, the lower the interior temperature.
-
0 means off.
Turn the knob to 4 for normal use, turn it between 4-7 if you need a lower interior
-
temperature, and between 4-1, if you need a higher interior temperature.
ENGLISH
51
BOLERO COOLMARKET 2D ORIGIN 86 E
Publicité
