Bergstrom Dirna Compact N&D Diagnostic De Pannes page 21

COMPACT N&D
• Reprogram control.
• Replace control's battery and reprogram.
• Replace electronic control.
• Replace control.
!
(If the error persists contact an Authorised Service Centre).
• Disassemble the internal air distribution panel and correctly connect the cable of the
control panel and electronic control.
• Place the device at less than 45° tilt (The device must not operate with a tilt of 45
degrees or more to prevent damage to the compressor). The electronic control
detects the tilt so it should also be at less than 45°.
• Clear the obstruction from the drainage pipe and valve (For access you must
remove the device's external cover).
• Replace the EPDM seal (you must disassemble the device and thoroughly clean
the surface where the EPDM seal will be stuck).
• Seal the cabling outlet on the cover of the compartment of the evaporator and
centrifugal blower (For access you must removed the device's external cover).
Solution
21
EN