Publicité
Les langues disponibles
Les langues disponibles
en-us Service settings
To be able to use Home Connect®, you must first set up
the connection to the WLAN home network (Wi-Fi
the Home Connect® app.
After switching on the appliance, wait at least 2 minutes
until internal device initialization is complete. Only then
should you set up Home Connect®.
The Home Connect® app guides you through the entire
registration process. Follow the instructions in the
Home Connect® app to implement the settings.
Tips
Consult the Home Connect® documents supplied.
¡
Follow the instructions in the Home Connect® app as
¡
well.
Notes
Also note the safety information in this instruction
¡
manual and ensure that it is also observed when
operating the appliance using the Home Connect® app.
→ "Safety", Page 4
Operating the appliance on the appliance itself always
¡
takes priority. It is not possible to operate the appliance
using the Home Connect® app during this time.
12.1 Setting up the Home Connect® app
Install the Home Connect® app on your mobile device.
1.
Start the Home Connect® app and set up access for
2.
Home Connect®.
The Home Connect® app guides you through the entire
registration process.
12.2 Setting up Home Connect®
Requirements
The Home Connect® app is installed on your mobile
¡
device.
The appliance receives signals from the WLAN home
¡
network (Wi-Fi) at its installation location.
Open the Home Connect® app and scan the following
1.
QR code.
1
Wi-Fi is a registered trade mark of the Wi-Fi Alliance.
18
Follow the instructions in the Home Connect® app.
2.
1
) and to
12.3 Remote diagnostics
The Customer Service can access your appliance via
Remote Diagnostics if you ask them to do so, if your
appliance is connected to the Home Connect® server and
if Remote Diagnostics is available in the country where
you are using the appliance.
Tip: Further information and details about the availability
of Remote Diagnostics in your country can be found in the
Service/Support section of your local website: www.home-
connect.com.
12.4 Data Protection
Please see the information on data protection.
The first time your appliance is registered on a home
network connected to the Internet, your appliance will
transmit the following types of data to the Home Connect®
server (initial registration):
Unique appliance identification (consisting of appliance
¡
codes as well as the MAC address of the installed Wi-Fi
communication module).
Security certificate of the Wi-Fi communication module
¡
(to ensure a secure data connection).
The current software and hardware version of your
¡
appliance.
Status of any previous reset to factory settings.
¡
This initial registration prepares the Home Connect®
functions for use and is only required when you want to
use the Home Connect® functions for the first time.
Note: Please note that the Home Connect® functions can
be utilized only with the Home Connect® app. Information
on data protection can be called up in the Home Connect®
app.
13 Service settings
Service settings
You can implement various service settings.
Service settings
13.1 Changing service settings
Swipe to "Service".
1.
"Application Info" lights up.
a
Touch and change the required service setting.
2.
Publicité
