Black Diamond RECON LT Manuel D'instructions page 18

4.8.6 Multiple burials | MARK function
A multiple burial is indicated clearly on the display by the number of small human figures (2G, 2H).
Marking is possible from a distance reading of 5 m and is indicated by the MARK symbol (2E). Press the MARK
button (1D) briefly to "hide" the localized transmitter. A successful flagging is confirmed by a frame around the
human figure (2J). The display then indicates the direction/distance to the next strongest signal inside the
receiving range. If there are no further signals within the receiving range the display indicates "no signal".
Continuous wave indication | old-device-indication
Old analog transceivers are transmitting a continuous wave in addition to the pulse signal. To keep an impact at a
minimum, it is recommended to step a few meters away after marking such a transmitter.
Signal without continuous wave
The BLACK DIAMOND RECON LT identifies a continuous wave and
supports visually by flashing human figures.
Manual BLACK DIAMOND RECON LT
prior to marking
De-mark a single signal: press the MARK button
(1D) for 3 seconds.
De-mark all: switch to SEND mode and then back
to SEARCH mode.
Signal with continuous wave
after marking
10 / 22