Waeco CoolMatic HDC-160 Notice D'emploi page 21

_hdc160-190-220.book Seite 21 Freitag, 4. Juli 2008 4:51 16
HDC-160, HDC-190, HDC-220
7 1, page 5: this refers to an element in an illustration. In this case, item 1
in figure 7 1 on page 5.
Please observe the following safety instructions.
2 Safety instructions
Caution!
WAECO International will not be held liable for claims for damage
resulting from the following:
– Damage to the device resulting from mechanical influences and
overvoltage
– Alterations to the device made without the explicit permission of
WAECO International
– Usage for purposes other than those described in the
installation manual
2.1 General safety
Have a trained technician make installations in wet rooms.
Do not operate the device if it is visibly damaged.
This device may only be repaired by qualified personnel.
Inadequate repairs can lead to considerable hazards.
Should your device need to be repaired, please contact
WAECO customer services.
Do not open the refrigerant circuit under any circumstances.
Place the device in a dry location where it is protected against
splashing water.
Do not place the device near naked flames or other heat
sources (heaters, direct sunlight, gas ovens etc.).
Ensure that the ventilation slots are not covered.
The device is not suitable for storing caustic materials or
materials containing solvents.
Before starting up the device for the first time, check whether
the operating voltage and the battery voltage correspond
(see type plate).
Danger of fatal injuries!
When using the device on boats: if the device is powered
by the mains, ensure that the power supply has a ground fault
interrupter circuit.
Safety instructions
21