FAFREES F20 Mate Manuel D'instructions page 15

Before connect the display cable, first turn off the battery power. Press the battery's power button to
the 0 position. Then connect the display cable, making sure to align the marks on both ends of
the display cable before inserting in. If the battery power is on before the communication cable of the
display is connected, it is easy to cause damage to some circuits of the controller.
Step 8: Inflate tires.
Check that the tire beads and tires are evenly seated on the rims. Use a pump with a Schrader valve to
inflate each tire to the recommended pressure indicated on the tire. Do not overinflated or underinflate
tires.
BATTERY CHARGING
Charging procedure
Follow these steps for charging your ebike battery from Fafrees Bikes:
BATTERY CHARGING INFORMATION
Check the charger, charger cables, and battery for damage before beginning each charge.
Be sure to charge in an area where it is clear and safe from any potential damage or tripping situations
can occur while it is charging. Always charge your battery in temperature between 0℃– 40℃ (32℉–
104℉).
The battery can be charged on or off the bike. To remove the battery, turn the key to the unlocked
position, and take the battery out.
The battery should be recharged after each use, so it is ready to go the full range for your next ride.
There is no memory effect, so charging the battery after short ride will not cause damage.
The indicator light on the charger will show red light while the battery charges. When charging is
complete, the indicator light will turn green. Ensure the light faces upward when charging.
Remove the charger from the battery within one hour of the green light indicating a complete charge.
The charger is designed to automatically stop charging when the battery is full, but unnecessary wear of
EN
1. Ensure the battery is off.
2. Remove the rubber cover on the charging port.
3. Plug the charger into the battery ' s charging port, BEFORE
PLUGGING CHARGER INTO POWER OUTLET.
With the battery on or off the bike, place the charger in a flat, secure
place, and connect the DC output plug from the charger to the charging
port on the side of the battery.
4. Plug the charger into a power outlet: Connect the charger
input plug (110/240-volt plug) to the power outlet. Charging should
initiate and will be indicated by the LED charge status light on the
charger illuminating as red light.
5. Unplug the charger from the outlet, then the charging port: Once
fully charged, indicated by the charging indicator light turning green,
unplug the charger from the wall outlet first and then remove the
charger outlet plug from the battery charging port.
12