Publicité
Les langues disponibles
Les langues disponibles
ASSEMBLY INSTRUCTIONS
FAUCET AND DRAIN KIT
9.
Slide the faucet body (F) from underneath
into the faucet sink hole and position the
gasket (G) in place.
10.
Slide the locknut (H) up to the gasket and tighten
the locknut by hand until snug. Use a wrench to
ensure it is fully tightened with the faucet handle
horizontal to the end of the tub.
Carefully grab the entire sink assembly and flip it
11.
over. Move the sink into position to connect your
water lines and waste pipe.
12.
Attach the counterweight (J) to the faucet line.
Position the counterweight at the lowest point
of the line. Adjust as needed.
13.
Push together the faucet quick connect line
to the supply lines.
14.
Position the laundry tub in its installation location.
Connect the flexible water supply lines (I) to the
hot and cold supply lines.
Note: Ensure the hot supply line (marked red)
connects to the hot supply and the cold supply
line (marked blue) connects to the cold supply
line. If additional supply line length is needed,
installer must purchase additional parts separately.
F
G
H
J
7
I
Publicité
