Publicité
Les langues disponibles
Les langues disponibles
1. Remove the 3.2" x 10" (8.3 x 25.4 cm) rectangular vent
connector attached with screws or taped on the inside your
range hood.
NOTE: Some models are recirculation (non-ducted only) and will
not have vent connector.
models:ESN130
EFS130S1
ERS230
A. Screws
B. 3.2 "X 10" (8.3 X 24.4 cm)
rectangular vent connector
2. Lift the range hood up under cabinet and determine final
location by centering beneath cabinet. Mark on the underside
of cabinet the location of the 4 keyhole mounting slots on the
range hood. Set range hood aside on a covered surface.
A
A. Keyhole slot
3. Use .11" (3 mm) drill bit and drill 4 pilot holes as shown.
A. Drill pilot hole
4. Install the 4 - 4.5 mm x 13 mm mounting screws in pilot
holes. Leave about .25" (6.4 mm) space between screw heads
and cabinet to slide range hood into place.
5. Remove transition knockouts depending on your model.
A. Round vent knockout
B. Top rectangular vent knockout
C. Rear rectangular vent knockout
B
A
A
"
(6.4 mm)
A
B
C
Round vent system installations - Remove top rectangular
and round vent knockouts.
Rectangular vent system installations - For roof
installations, remove the top rectangular vent knockout. For
wall installations, remove the rear rectangular vent knockout
Non-ducted (recirculating) installations - Do not remove
any knockouts.
5. Remove metal grease filters. See the "Range Hood Care"
section. For the ENM230, ENM236 series models, first remove
the lateral panels.
A
7. For round installation: Install 7" (17.8 cm) round vent mounting
plate and damper or 3.25" x 10" (8.3 x 25.4 cm) vent
connector, depending on your vent system installation.
(Purchase as an accesory).
9
model: ENM230
A
A. Lateral panels
B. 3.25" x 10" (8.3 x 25.4 cm)
rectangular vent connector
B
A
A. 7" (17.8 cm) Round damper
B. Sheet metal screws
B
C. 7" (17.8 cm) round vent mounting plate
D. Round vent knockout
C
E. Rectangular vent knockout
D
E
ENM236
Publicité
