EINHELL HES 55 Mode D'emploi page 7

Anleitung HES 55 -12 sprachig
Description
1. Handle
2. Nameplate
3. On/Off switch
4. Interlock button for On/Off switch
5. Lock screw for the depth of cut setting
6. Power cable
7. Splitter
8. Hinged guard hood
9. Allen screw
10. Shoe
11. Flange
12. Saw blade
13. Parallel stop
14. Lock screw for the parallel stop
15. Lock screws for mitre cuts
16. Dust extractor connection
17. Additional handle
18. Actuator for the hinged guard hood
Please read these instructions carefully and pay
particular attention to the safety regulations. Keep
the instructions together with the circular saw.
Technical data
Voltage
Power rating
Idle speed
Cutting depth at 0°
Cutting depth at 45°
Saw blade
Saw blade mount
Saw blade thickness
Sound pressure level
Sound power level
Vibration a
W
Weight
Dimensions
Totally insulated
Accessories supplied
Parallel stop
Applications
The hand-held circular saw is designed for sawing
straight cuts in wood, in materials similar to wood,
and in plastics.
13.11.2001 8:14 Uhr
Safety regulations
Adjust the splitter so that it is no more than 5 mm
from the tooth rim of the saw blade and its lowest
point is not retracted more than 5 mm relative to
the tooth rim.
Do not use cracked or misshapen saw blades.
Do not use saw blades made of high-alloy, high-
speed steel (HSS).
Never use saw blades which do not conform with
the specifications quoted in these instructions.
Make sure that all the moving parts of the blade
guard work properly without jamming.
Make sure that all devices which play a role in
covering the saw blade are in proper working
order.
The splitter must be properly adjusted and used at
all times except for plunge-cuts.
Do not use the saw near fumes or combustible
liquids.
Use only sharp blades and suitable accessories.
Always pull the plug out of the socket before
converting, cleaning or adjusting the saw.
Keep the power cable safe from damage. Oil and
acid can cause damage to the cable.
230 V ~ 50 Hz
Never use saw blades with plates that are thicker
1020 W
or with sets that are smaller than the thickness of
4000 rpm the splitter.
Never remove the plug from the socket by pulling
52 mm
on the power cable and do not carry the saw by its
40 mm
cable.
160 mm dia.
Have repairs carried out only by specialists.
If you use a cable reel, the complete cable must
20 mm dia.
be drawn off the reel. The conductor must have a
2,8 mm
minimum cross section of 1.5 mm
rating 16 A.
LPA 98 dB(A)
Secure all workpieces sufficiently and do not
LWA 101 dB(A)
overload the machine.
3.2 m/s 2
Wear suitable clothing and goggles and use a dust
mask on dusty jobs.
4.8 kg
Wear ear muffs to protect your ears!
33 x 22.5 x 22 cm
For lengthy jobs on wood and when cutting
materials which produce a great deal of dust, the
circular saw should be connected to a suitable
dust extractor (observe you country's regulations
regarding wood dust extraction).
Seite 7
2 . Maximum fuse
GB
7