Batavia BT-TL014 Mode D'emploi page 19

length is reached (see fig. D).
With the aid of the locking
device, each section is automati-
cally locked as soon as the cor-
responding rung
to its maximum.
4. Make sure that each and every
ladder section is locked before
you climb onto the ladder (see
section "Locking device").
Extending the ladder to its total
length
1. Set up the ladder on a solid and
level ground.
2. Stabilise the ladder by placing a
foot on the support foot
3. Extend the ladder from the top
down, rung by rung until the total
length is reached
(see fig. E and F).
Keep in mind that the locking
devices of the ladder only lock
when you have extended the lad-
der to its total length.
4. Make sure that each and every
ladder section is locked before
you climb onto the ladder (see
section "Locking device").
Retracting the ladder
If you activate the lowest
unlock keys (on the sec-
ond rung from below), all
rungs of the above ladder section
are automatically unlocked and
retracted. If you begin with one of
the upper rungs, this only unlocks
has extended
5
.
2
the rungs above it and the rungs
below must be unlocked separately.
1. Make sure that the ladder stands
on a solid and level ground.
2. When retracting the ladder
ensure that your fingers, hands
and arms are at the height of the
actuated unlock keys
3. Push both unlock keys of a rung
towards the centre so that the
red area below becomes visible.
(see fig. G).
The locking device unlocks and
the remainder of the ladder
above the rung is retracted.
Cleaning and maintenance
WARNING!
Risk of injury!
There is a risk of injury
with incorrect handling.
If rungs or beams are
contaminated, you can easily slip or
fall off the ladder and injure
yourself.
– Keep the ladder clean. Remove
contaminates, such as, e.g. dirt,
paint residues etc., after each
use and before retracting the
ladder.
– Always wipe the rungs off.
– Leave repair and maintenance
work to be carried out exclusively
by experts.
– If necessary, contact the
manufacturer or distributor for
English
.
1
19