AL-KO 569 Solo Traduction Du Mode D'emploi Original page 26

OPERATING ELEMENTS
Gas lever
24
The engine speed is regulated with the gas lever. In order to
mow as effectively as possible, the gas lever should be swit-
ched to
Light switch
Use the light switch to switch the headlights on.
Ignition lock
To start the engine, put the ignition key into the ignition lock
and turn to the right to position "II".
As soon as the engine is running, let go of the ignition key
(ignition key returns to position "I").
To switch the engine off, put the gas lever onto
then turn the ignition key onto position "0".
Mowing appliance switch
29
The mowing appliance is operated with this toggle switch.
Switch position I - mowing appliance switched on
Switch position 0 - mowing appliance switched off
Meaning of the symbols on the pedal
25
Clutch
Brake
.
GB
"Clutch / Brake" pedal
25
If the pedal is half pushed down, the clutch is disenga-
ged. If the pedal is completely pushed down, the clutch
is disengaged and the disk brake of the transmission
operated.
With the pedal completely pressed down, the pedal can
be locked in the "Brake" function by pushing the stop
lever to the left (with the heel of the shoe).
Pushing the pedal down again cancels the locking - the stop
lever returns to the original position.
Switching lever (for hydrostat drive)
26
Possible transmission positions:
Forward gear - infinitely adjustable
Reverse gear - infinitely adjustable
and a neutral position.
,
For safety reasons, the switching lever must always
be in the neutral position when engaging traction.
Switching lever (for 5-gear transmission)
28
With the switching lever,
5 forward gears
1 reverse gear
and1 neutral position can be switched.
Position lever for adjustment of cutting
29
height
The mowing appliance is lifted or lowered with the position
lever.
Six positions are available. In order to get from a higher to a
lower position, the push button on the end of the lever must
be pushed to unlock it.
In order to reach a higher position, simply push the lever
upwards into the required position
GB13