Wood's SILENT Guide D'instructions page 7

PROBLEM SOLUTION
Dehumidifier does not start - Check that the dehumidifier is properly connected to an electrical source and that the fuse has not gone
- If the warning light is on, check that the water reservoir is empty and correctly placed in the dehumidifier.
Check that the float is free
- Check that hygrostat is working. Dehumidifier should start when hygrostat is in Maximum position
Does not dehumidify - Check that fan is spinning
- Check that air can flow freely through the dehumidifier. Front grid and air filter should be clean and dehumidifier should stand
20-30cm from wall
- Listen for the sound of the compressor, bear in mind that the dehumidifier may be in a defrost cycle, when the compressor stops. Wait initially for about 35 minutes.
- Check that a thick coating of ice has not formed on the cooling coils.
High noise level/vibrations - Increase distance between dehumidifier and surrounding surfaces
- Cooling coils may be in contact with each other and cause vibration. Disconnect dehumidifier from electricity and separate the coils
Ice formation on cooling coils - Remove air filter at rear of dehumidifier and check that no dust is obstructing the air going through machine
No water enters reservoir - Check for obstruction in the drip-tray above the water reservoir
Does not switch off when water - It is important that the float moves freely in the water reservoir. If it does not, it will not respond to water levels and prevent dehumidifier from stopping
reservoir is full
The Led is flashing in green - To low temperature- increase room temperature.
If none of the above works, you should contact your nearest retailer for checking other possible solutions.
Operating Instructions
GB
7