Bosch Benchmark NITP668UC Manuel D'utilisation Et D'entretien page 17

Panel Lock
You can use the panel lock to prevent children from
accidentally turning the appliance on.
Activating and deactivating the panel lock
The cooktop must be turned off.
To activate:
Switch on the cooktop using the main switch.
1.
Touch the Panel Lock key for approx. 4 seconds.
2.
The indicator lights up for 10 seconds.
D
The cooktop is locked.
To deactivate:
Switch on the cooktop using the main switch.
1.
Touch the Panel Lock key for approx. 4 seconds.
2.
The lock is released.
Automatic panel lock
With this function, the panel lock is automatically
activated whenever you turn off the cooktop.
Turning on and off
See "Basic settings" section.
Basic settings
The appliance has various basic settings. You can adjust
these settings to the way you usually cook.
Display Function
Automatic child lock/panel lock
Manual*.
‹
Automatic.
‚
Function deactivated.
™‚ ƒ
Signal tones
Confirmation and error signals are switched off.
‹
‚ Only the error signal is switched on.
Only the confirmation signal is switched on.
ƒ
All signal tones are switched on.*
™ƒ „
Display energy consumption
Switched off.*
™„ ‹
Switched on
‚
Automatically setting the cooking time
‹‹ Switched off.*
- Time until automatic switch-off.
™† ‹‚ ŠŠ
* Factory settings
Wipe protection
Cleaning the control panel while the cooktop is on may
change the settings. In order to avoid this the cooktop
has a wipe protection function.
To activate: Touch the Panel Lock key. An acoustic
signal sounds. The control panel is locked for
35 seconds. You can now wipe over the surface of the
control panel without altering any settings.
To deactivate: The control panel will be unlocked once
35 seconds have elapsed. To release the function early,
touch the Panel Lock key.
Notes
An audible signal sounds 30 seconds after activation.
▯
This indicates that the function is about to finish.
The wipe protection function does not lock the main
▯
switch. The cooktop can be switched off at any time.
Automatic time limitation
If the element is used for prolonged periods of time
without changes in the settings being made, the
automatic time limitation function is triggered.
The element stops heating.
indicator • / œ flash alternately in the display.
The indicator goes out when any symbol is pressed. The
element can now be reset.
When the automatic time limitation is activated depends
on the selected heat level (from 1 to 10 hours).
and the residual heat
"‰
17