Heat Storm HS-6000-GC Guide D'utilisation page 6

STEP 2: CONNECT POWER
Heat Storm Infrared Heaters are considered to be an appliance�
Each heater and appliance should be on its own circut�
The energy supply must be done through a properly grounded power
block� Ensure the cord is not under carpeting, covered with rugs,
runners, or similar coverings� Avoid routing it under furniture or
appliances and position it away from high-traffic areas to prevent
tripping hazards�
1
Unscrew the four screws to remove the connector cover� Use a
maximum 30A fuse for branch circuit protection and only use
copper wire�
2
Insert the cable with 8-gauge internal wires into the chamber
through the top hole� Connect line 1 and line 2 (L1, L2) and the
ground wire� Secure the wires with the clip inside the chamber�
6
GROUND
L1
L2
CABLE