Heat Storm HS-6000-GC Guide D'utilisation page 12

3
Configuration process
Wait for the connection to be completed. Please be patient,
as this may take a few minutes� The app will notify you that
the device was successfully added� Select "done" to enter the
control interface�
EZ MODE - MANUAL CONNECT
1
Add device
i� When the machine is on, press and hold the Wi-Fi/sun
button on the control panel for 5 seconds until the Wi-Fi
indicator light begins flashing.
ii� In the app, tap the plus icon in the top right corner�
iii� Select "Add device�" Choose "Small home appliance�"
iv� Tap "Heater (Wi-Fi)�"
2
Choose Wi-Fi
Enter your case-sensitive Wi-Fi network name and password, then
tap "Confirm." Press "Next" if it is asking you to reset your heater.
3
Configuration mode
Confirm the Wi-Fi indicator light on control panel is flashing
quickly and select "blinking quickly" within the app� Then click
on "Finish network configuration".
4
Configuration process
Wait for the connection to be completed. Please be patient,
as this may take a few minutes� The app will notify you that
the device was successfully added� Select "done" to enter the
control interface�
Maintenance
CLEANING
To maintain optimal performance, it is advised to clean the air
inlet of the heater every six months� In the event of heavy dirt
accumulation, use a soft cloth and brush to gently wipe it off. Prior
to cleaning, disconnect the power supply to allow the heater to cool
down� This ensures a safe and effective cleaning process�
12