Bestron COPPER AHM1000CO Mode D'emploi page 25

WARNING:
• Switch off the appliance (turn the speed dial to the '0' position) and remove the plug from the wall
socket before you attach the accessories.
Insert the shaft of the accessory in the opening on the underside of the mixer. The pins projecting from the
accessory fit in the recess. Press the accessory into the opening; a 'click' will be heard when the accessory
locks in position. Use the same procedure to fit the second accessory.
OPERATION - Removing the accessories
WARNING:
• Switch off the appliance (turn the speed dial to the '0' position)
andremove the plug from the wall socket before you remove
the accessories.
If the speed dial is not turned to position "0", you cannot remove
the attachments. The release button cannot be pressed to release
the attachments.
To remove the accessories hold them with one hand whilst pressing
the release button with the other hand.
CLEANING AND MAINTENANCE
1. Remove the plug from the wall socket.
2. Remove the accessories from the appliance (see 'Removing the accessories'). You can clean the
accessories in washing-up solution, or place them in a dishwasher. Rinse the accessories with ample
water, and dry them thoroughly.
3. Clean the motor housing of the appliance with a damp cloth. After cleaning, dry it thoroughly.
4. Store the appliance.
WARNING:
• Verify that the plug is out of the socket before you clean it.
• Clean the accessories after each use.
• Never use corrosive or scouring cleaning agents or sharp objects (such as knives or hard brushes) to
clean the appliance.
• Do not immerse the motor unit in water, or in other liquids.
25
EN