VITO PRO POWER VISCB20 Mode D'emploi page 43

1. Unscrew the fixing knob at the rear;
2. Unscrew the fixing knob at the front;
3. Adjust the saw blade tilt according to the scale;
4. Tighten both knobs.
1.
2. and 3.
The table saw was conceived to operate over a long period
of time with a minimum of maintenance. For a continuous
and trouble-free operation, you must perform regular
cleaning and proper maintenance tasks.
Before inspecting, performing any maintenance or
cleaning, turn off the table saw and unplug the power cord.
1. Remove the dust collection hose (6) and the blade guard
(3);
2. Remove the 6 screws and the plate from the table/saw
blade;
3. Raise the saw blade (4) to its maximum height;
4. Use the hex wrench to loosen the nut that holds the saw
blade;
This nut is left-hand threaded, as such it can be
loosened counter-clockwise.
5. Remove the nut and washer;
6. Replace the saw blade by placing it in the correct
position;
7. Proceed in the opposite order to complete this
procedure.
2.
4. 5. and 6.