VITO PRO POWER VISCB20 Mode D'emploi page 38

1. Turn the table saw upside down and lay it down on a
workbench;
2. Secure each leg to the corresponding corner, following
the letters marked on the legs and on the table.
Example: leg A in corner A. Use 4 flat head screws, 4
spring washers, 4 plate washers and 4 nuts on each leg;
3. Secure the longitudinal cross bars to the legs using 1 flat
head screw, 1 plate washer, 1 spring washer and 1 nut
for each leg;
4. Secure the transverse cross bars to the legs using 1 flat
head screw, 1 plate washer, 1 spring washer and 1 nut
for each leg;
5. Use 4 hex screws, 4 plate washers, 4 spring washers and
4 nuts to fix the longitudinal cross bars to the transverse
cross bars;
Make sure that the holes longitudinal and transverse
cross bars point upwards for further assembly of the
table extension.
6. Install the rubber feet to the bottom of the legs.
2.
3. and 4.
5.
Tighten the wheels on the rear legs using 2 hex screws, 2
plate washers, 2 spring washers and two nuts on each leg.