Publicité
Les langues disponibles
Les langues disponibles
1. Insert the miter gauge (1) into the slot of the side guide
rail;
2. Tighten the screw to fix it in the desired position;
3. Tighten the screw to set the desired cutting angle.
1.
2.
1. Place the rip on the front guide rail;
2. Lower the clamping handle (14) in the desired position.
1.
2.
The table extension can be attached to both back and right
side of the table saw.
On the rear
1. The 40 cm side (2 holes) touches the back of the
worktable and tighten it with 2 hex screws, 2 plate
washers, 2 spring washers and 2 nuts;
2. Use the support bars A which are secured to the rear
cross bar with 2 hex screws, 2 plate washers, 2 spring
washers and 2 nuts. They are also secured to the
extension table in the two holes at the ends.
1.
2.
A
.
B
.
Publicité
