VITO PRO POWER VISCB20 Mode D'emploi page 40

Fasten the sawdust extractor (10), using 4 screws.
Screw the hook to the left front leg.
Fasten the dust collection hose hook holder to the left rear
leg.
1. Align the riving knife hole with the blade guard hole (3);
2. Insert the screw, from right to left;
3. Place a plate washer, a spring washer, a plate washer
and finally a nut.
1. Fit one end of the dust collection hose (6) into the blade
guard;
2. Pass the other end through the dust collection hose
hook holder;
3. Fit this end into the sawdust extractor.
1.
3.
2.