Nordpeis Amsterdam Manuel D'installation page 5

Amsterdam Corner
Insert
N-24
Steel chimney
Can be installed with steel chimney.
Weight including insert (excl. wood shelf)
Amsterdam Corner
Amsterdam Corner Waxed
Illustration (FIG 1)
*The illustration indicates the approximate centre height
of the hole for the flue. Consider possible inclination of
the flue prior to perforating the chimney. Distortions in
floors and walls may influence the height. Dry stack the
fireplace for accurate height and positioning of the
flue/chimney connection.
If a fresh air supply set is connected through the floor,
mark where the hole should be.
FIG A indicates recommended floor area.
Safety Distances (FIG 2)
Ensure that the safety distances are complied with.
Please note that these safety distances can vary from
country to country.
The distance from the glass in the door to a lateral wall,
measured diagonally, must be of at least 300 mm.
The distance between the top of the convection air
outlet and roof of inflammable material must be at least
380 mm.
The distance to any inflammable material in front of the
opening of the insert must be of at least 1 m.
Assembly instructions (FIG 3 - FIG 17)
Amsterdam Corner can be assembled with the built in
wood storage to the left or to the right by mirroring the
assembly. Two different top elements are included,
choose the one that fits your chosen assembly.
FIG 3: If the fireplace is connected to a chimney at the
349 kg
474 kg top, the smoke lid must be moved to the rear flue outlet.
FIG 5: Place the bottom plate in 90º relative to the
chimney/wall. If needed, adjust with wedges or powder
glue.
FIG 7: Please note! Ensure to seal well between the
bottom element and the lower front when the fireplace is
placed on a combustible floor.
FIG 8 / FIG 10 / FIG 13: Ensure that there is a gap
between the insert and the surround as the insert
expand with heat. Also read the section about
adjustment.
FIG 15: When using the wood storage unit, cut the
element 16 to the required width.
Once the fireplace is assembled, fill the joints with
acrylic and even them out with a sponge or finger and
some soapy water, in order to have a clear indentation
between the elements (FIG Z).
GB
5