Panasonic Technics SU-G700 Mode D'emploi page 23

Analogue audio cable (not supplied)
Do not input the audio signal from PRE
OUT/LINE OUT terminals to the analogue
audio input terminals of this unit. Doing so
may cause malfunction.
Using analogue audio input device
You can connect the CD recorder, etc. with analogue
audio cable (not supplied) to output analogue audio
signals from this unit (LINE1/LINE2/PHONO).
Using analogue audio cable
1 Disconnect the AC mains lead.
2 Connect this unit and a CD recorder,
etc.
3 Connect the AC mains lead to this unit.
( 15)
4 Press [AMP
Note
• When a digital audio signal (COAX1/COAX2/
OPT1/OPT2/PC) is selected as input source
of this unit, analogue audio signal (LINE1) is
output.
• The choppy audio occurs in output audio signal
when switching the input source.
CD recorder, etc.
] to turn this unit on.
Operations
23
(23)