WMF BUENO Mode D'emploi page 13

Acrylamide is generated during excessive browning. Excessive browning of
the toast should therefore be avoided.
Interrupting the toasting process
Press the illuminated button to interrupt the toasting process.
Warming / retoasting
If the warming button is pressed immediately after switching on the appliance,
cold but already toasted bread will be crisped up and too lightly toasted bread
will be slightly retoasted.
Defrosting
If this button is pressed directly after the appliance is switched on, the toas-
ting cycle will be extended automatically to toast frozen bread.
Removing the toast
With the integrated automatic lift mechanism, small slices of bread can also be
removed safely and easily.
Bread roll attachment
The toaster is fitted with an integrated roll attachment, which can be used by
pressing the button downwards.
Two rolls can be warmed up from either side on a medium setting in each case.
Rolls which are too dry should be moistened slightly beforehand - it works better
this way.
Crumb tray
Crumbs produced during toasting are collected in the crumb tray.
You can then pull the tray out of the appliance.
Cleaning and maintenance
Before cleaning, disconnect the appliance from the mains and allow the appliance
to cool down. Use a hard brush to remove crumbs sticking to the grids and the
heater. Do not tilt the appliance while you do this, or crumbs will spill from the
crumb tray into the inside of the toaster. Then pull out the crumb tray, clean it
and reinsert.
Never immerse the toaster in water. Wipe the outside of the appliance only with
a damp cloth and some washing-up liquid. Do not use harsh or abrasive cleaning
agents.
13