Publicité
Les langues disponibles
Les langues disponibles
NoSePieCe rePlACeMeNt
1. unplug the tool before changing the nosepiece.
2. remove retention screw with flat-tip screwdriver.
3. Set the nosepiece on the longest setting possible.
4. Depress the screw selector pin until it is completely depressed. it will be necessary to use a screw or
thin object to depress to this depth.
5. while holding the pin in this position, slide the nosepiece forward and off the slide body
6. install the new nosepiece.
7. replace the nosepiece retention screw ensuring it is seated snug against the slide body.
belt Hook ADjuStMeNt
to adjust the belt hook offset from the tool:
1. remove the belt hook thumb screw until the locking plate can be removed.
2. Slide the belt hook out to the desired position, replace the locking plate, then re-install the thumb
screw.
to relocate the belt hook to opposite side of the tool:
1. remove the thumb screw, locking plate, threaded plate and belt hook.
2. insert the threaded plate on the opposite side of tool and re-install the hook at the desired position
using locking plate and thumb screw.
tool oPerAtioN
9
Publicité
