Replacing The Lamp; Installation - FUST NOVOMATIC SUPER ÖKO+ 2230.1-IB Notice D'utilisation

51
certificate or on the rating plate located on
the external right side of the appliance.

Replacing the lamp

The appliance is equipped with
a longlife LED interior light.
WARNING! Do not remove the
lamp cover at the time of
replacement. Do not operate the
freezer if the lamp cover is
damaged or missing.
1. Disconnect the mains plug from the
mains socket.
2. Replace the used lamp with a new lamp
of the same power and specifically

INSTALLATION

WARNING! Refer to Safety
chapters.
Positioning
This appliance can be installed in a dry, well
ventilated indoor where the ambient
temperature corresponds to the climate
class indicated on the rating plate of the
appliance:
Cli- Ambient temperature
mate
class
SN +10°C to + 32°C
N +16°C to + 32°C
ST +16°C to + 38°C
T +16°C to + 43°C
designed for household appliances (the
maximum power is shown on the lamp
cover).
3. Connect the mains plug to the mains
socket.
4. Open the lid. Make sure that the lamp
comes on.
Some functional problems might
occur for some types of models
when operating outside of that
range. The correct operation
can only be guaranteed within
the specified temperature range.
If you have any doubts
regarding where to install the
appliance, please turn to the
vendor, to our customer service
or to the nearest Authorised
Service Centre.
The plug should be accessible
after installation.
Electrical connection
• Before plugging in, ensure that the
voltage and frequency shown on the
rating plate correspond to your domestic
power supply.
• The appliance must be earthed. The
power supply cable plug is provided with
a contact for this purpose. If the
domestic power supply socket is not
earthed, connect the appliance to a
separate earth in compliance with
current regulations, consulting a qualified
electrician.