Customer Service; Replacing The Lamp - FUST NOVAMATIC SÖ1840-IB Notice D'utilisation

53
Problem
Temperature cannot be set.
The temperature in the appli-
ance is too low/too high.

Customer Service

If your appliance is still not working properly
after making the above checks, contact the
nearest Authorised Service Centre.
To obtain fast service, it is essential that
when you apply for it you specify the model
and serial number of your appliance which
can be found either on the guarantee
certificate or on the rating plate located on
the external right side of the appliance.

Replacing the lamp

WARNING! Do not remove the
lamp cover at the time of
replacement. Do not operate the
freezer if the lamp cover is
damaged or missing.
1. Disconnect the mains plug from the
mains socket.
Possible cause
The ActionFreeze function is
switched on.
The temperature regulator is
not set correctly.
The lid is not closed correct-
ly.
The products' temperature is
too high.
Many products are stored at
the same time.
The thickness of the frost is
greater than 4-5 mm.
The lid has been opened of-
ten.
The ActionFreeze function is
switched on.
Products to be frozen are
placed too closely to each
other.
2. Replace the used lamp with a new lamp
of the same power and specifically
designed for household appliances (the
maximum power is shown on the lamp
cover).
3. Connect the mains plug to the mains
socket.
4. Open the lid. Make sure that the lamp
comes on.
Solution
Refer to "ActionFreeze func-
tion".
Set a higher/lower tempera-
ture.
Refer to "Opening and clos-
ing the lid".
Let the product temperature
decrease to room tempera-
ture before storage.
Store less products at the
same time.
Defrost the appliance.
Open the lid only if necessa-
ry.
Refer to "ActionFreeze func-
tion".
Make sure that there is cold
air circulation in the appli-
ance.