Problem
It is too cold inside the
freezer
The appliance does not
work at all. Neither cool-
ing nor lighting works
Customer Service
If your appliance is still not working properly
after making the above checks, contact the
nearest service centre.
To obtain fast service, it is essential that
when you apply for it you specify the model
Replacing the lamp
Possible cause
Before freezing the appliance
was not precooled sufficiently
Large quantities of food to be
frozen were put in at the same
time
Food placed in the appliance
was too warm
Products to be frozen are
placed too closely to each other
The lid has been opened often
The lid has been opened for a
long time.
The temperature is not set cor-
rectly.
Plug is not connected to the
mains socket properly
Power does not reach the appli-
ance
The appliance is not switched
on
The thermostatic control is not
on
There is no voltage in the mains
socket (try to connect another
appliance into it)
1. Disconnect the mains plug from the
2. Replace the used lamp with a new
3. Connect the mains plug to the mains
4. Open the lid. Make sure that the lamp
Pre-cool the appliance for enough
time
Wait some hours and then check
the temperature again. Next time
insert smaller quantities of food to
be frozen at any one time.
Allow food to cool to room tem-
perature before storing.
Place the products in a way so
that cold air could circulate
among them
Try to not open the lid often
Do not leave the lid open longer
than necessary
Set a warmer temperature
Connect the mains plug properly
Try connecting another electrical
device to the power outlet
Switch on the appliance
Check setting of thermostatic
control
Call an electrician
and serial number of your appliance which
can be found either on the guarantee certifi-
cate or on the rating plate located on the
external right side of the appliance.
mains socket.
lamp of the same power and specifical-
ly designed for household appliances.
(the maximum power is shown on the
lamp cover)
socket.
comes on.
37
Solution