Philips AVENT SCD845 Mode D'emploi page 27

Environmental information
Remove the integrated battery
Warranty and support
All unnecessary packaging has been omitted. We have tried to make
the packaging easy to separate into two materials: cardboard (box and
polyethylene (bags, protective foam sheet).
Your system consists of materials which can be recycled and reused
if disassembled by a specialized company. Please observe the local
regulations regarding the disposal of packaging materials, exhausted
batteries and old equipment.
Note: We strongly advise you to have a professional remove the
rechargeable battery.
Only remove the rechargeable battery when you discard the appliance.
Make sure the battery is completely empty when you remove it. Only the
parent unit includes a battery.
Procedure:
1 Remove the 2 rubber feet at the bottom of the parent unit.
2 Remove the 2 screws that are now visible at the bottom of the parent
unit.
3 Put the antenna in upward position and remove the screw in the back
housing that is now visible.
4 Remove the back housing from the front housing by forcing a screwdriver
in between them. For newer versions manufactured after August 2020*,
there are 2 more screws underneath the rating label. Tear out the rating
label, remove the screws, release the belt clip and slide open the battery
compartment door.
5 Disconnect the battery connector cable (black-white-red cable).
6 Remove the 4 screws from the battery holder. No screws for new versions
manufactured after August 2020.
7 Remove the battery.
*The production date code DDMMYY is located underneath the belt clip,
above the 2 rubber feet.
If there is no collection/recycling system for electronic products in your
country, you can protect the environment by removing and recycling the
battery before disposing the product.
Make sure the product is disconnected from the charging case before
removing the battery.
If you need information or support, please visit www.philips.com/support or
read the international warranty leaflet.
27
English