Caloric CVP1030-SS Manuel D'utilisation Et D'installation page 9

Electrical Requirements
IMPORTANT: Observe all governing ordinances and local codes.
(Please consult with a qualified electrician for any electrical wiring)
It is the customer's responsibility:
• To contact a qualified electrical installer.
• To assure that the electrical installation is adequate and in conformance with National
Electrical Code, ANSI/NFPA 70 — latest edition*, or CSA Standards C22. 1-94, Canadian
Electrical Code, Part 1 and C22. 2 No. 0-M91 - latest edition**
be aware of and adhere to all building, fire, electrical, safety, and any other applicable
codes with regards to the installation and use of this range hood.
• Provide a circuit protected power service; preferably a Ground Fault Circuit Interrupter
("G.F.C.I."): 120-volt, 60 Hz, AC, with at least 5-amps of available service.
• Enlist a qualified electrician to ensure the range hood and electrical lines are adequately
grounded and properly protected. NEVER electrically ground to a gas pipe.
• IMPORTANT: Save this Installation Guide for future reference and/or electrical inspector
use.
• The range hood should be connected with a circuit breaker protected power service.
• Wire sizes (copper wire only) and connections must conform with the rating of the
appliance as specified on the model/serial rating label.
the requirements of the National Electrical Code and any and all local codes and
ordinances. A U.L. - or C.S.A. - listed conduit connector must be provided at
each end of the power supply cable (at the range hood and at the junction box).
Advanced Preparation
Advanced Preparations:
1. Familiarize yourself with the controls of the range hood
by reading through Range Hood Operations, Page 14.
2. Place the range hood on a flat, stable surface. Connect
the range hood to a designated standard outlet (please
refer the product label for the suitable voltage of this
unit) and turn on the range hood. Verify all operations
of the range by referring to Range Hood Operations,
Page 14.
3. Place all supplied parts and required hardware on a flat, stable surface and verify the
presence of all supplied parts listed on Page 4.
4. Carefully remove the white plastic protective coat from the range hood.
Wire sizes must conform to
Excessive Weight
Require three or more persons to
move and install this range hood.
Spinal or other bodily injuries
could occur if it is not followed.
Pg 8
It is your responsibility to