Caloric CVP1030-SS Manuel D'utilisation Et D'installation page 10

Preparation
NOTE: To avoid damage to your hood, prevent debris from entering the vent opening.
Decide the location of the venting pipe from the hood to the outside. Refer to Venting
Methods on page 7.
• A straight, short vent run will allow the hood to perform more efficiently.
• Try to avoid as many transitions, elbows, and long run as possible. This may reduce the
performance of the hood.
• Use aluminum foil tape to seal joints between pipe sections.
• For installing under the cabinet with recessed bottom, attach 4-inch wide wood filler
strips (not provided) on each side. Refer to Figure 1.
• Using references in Hood Dimensions drawing on Page 4, create access opening for
electrical wires and hood exhaust under the cabinet.
CAUTION: If moving the cooking range is necessary to install the hood, turn OFF the
power on of an electric range at the main electrical box. SHUT OFF THE GAS BEFORE
MOVING A GAS RANGE.
• Puncture the knockout holes (for mounting under the cabinet) on the hood as shown
in Figure 2.
• If necessary, attach two rubber pads with 3M adhesive tapes to the back corners of
the hood to reduce noise and vibration.
Figure 1
Pg 9
Figure 2