Caloric CVP1030-SS Manuel D'utilisation Et D'installation page 13

Installation
Measure the distance between stove top and the bottom of range hood. A distance of 27" to
30" is recommended*.
* Due to difference ceiling height configurations, recommended height may not applicable.
1. You have two ways (A or B) to mount this range hood:
A. Under Cabinet Hood Mounting
1. Using references in Height & Clearance on Page 5 and Hood Dimensions on
Page 4, center the hood beneath the cabinet and flush with the front of the
cabinet.
2. Draw electrical wires through the cabinet access opening and center the hood
beneath the cabinet.
3. From inside of the hood, place screws into the center of each knockout hole and
secure to cabinet bottom.
4. Finish tightening all screws until secure. Be careful when using power tools to
fasten screws as damage to the range hood may occur. Skip Part B below and
proceed to Step 2.
CAUTION: Make certain the range hood is secure before releasing!
B. Mount this range hood using the Hood-Mounting Bracket.
Note: Mounting the hood on wall studs is highly recommended.
1. Using references in Height & Clearance on Page 5 and the included Hood
Mounting Bracket, mark the leveling point of the hood. Insert two screws into
the wall, leaving 1/8th inch space between the head of the screw and the wall so
that the mounting bracket can be placed later.
2. Attach the hood-mounting bracket to the back of the hood with six (6) screws
shown on Figure 3.
3. Puncture the knockout wire access hole at the back of the hood and draw the
electrical wires through as shown in Figure 4.
4. Align the hood-mounting bracket to the screws on the wall and hook hood into
place as shown in Figure 5.
5. Tighten the screws to secure hood to the wall.
CAUTION: Make certain the range hood is secure before releasing!
Hood Mounting Bracket
Pg 12