Publicité
Les langues disponibles
Les langues disponibles
Burner cap: Always keep the burner cap in place when using a
surface burner. A clean burner cap will help avoid poor ignition
and uneven flames. Always clean the burner cap after a spillover,
and routinely remove and clean the caps according to the
"General Cleaning" section in the Owner's Manual.
Alignment: Be sure to align the gas tube opening in the burner
base with the orifice holder on the cooktop and the igniter
electrode with the notch in the burner base.
Gas tube opening: Gas must flow freely throughout the gas
tube opening for the burner to light properly. Keep this area free
of soil and do not allow spills, food, cleaning agents, or any other
material to enter the gas tube opening. Keep spillovers out of the
gas tube opening by always using a burner cap.
A.
" (2.5-3.8 cm) B. Burner ports
1-1
1
/
2
Burner Ports: Check burner flames occasionally for proper size
and shape as shown in the previous illustration. A good flame is
blue in color, not yellow. Keep this area free of soil and do not
allow spills, food, cleaning agents, or any other material to enter
the burner ports.
To Clean:
IMPORTANT: Before cleaning, make sure all controls are OFF
and the oven and cooktop are cool. Do not use oven cleaners,
bleach, or rust removers.
1. Remove the burner cap and the burner base, and clean
according to "General Cleaning" section in the Owner's
Manual.
2. Clean the gas tube opening with a damp cloth.
3. Clean clogged burner ports with a straight pin as shown.
Do not enlarge or distort the port. Do not use a wooden
toothpick. If the burner needs to be adjusted, contact a trained
repair specialist.
4. Replace the burner base. Each round burner base is marked
with a letter indicating the burner size. See the following
illustration for burner positions.
A
B
A.
Large (Rapid)
B.
Large (Rapid)
C.
Oval (OV)
D
C
E
D. Small (Auxiliary)
E. Large (Ultra Rapid)
5. Replace the burner cap, making sure the alignment pins are
properly aligned with the burner cap.
A.
Burner cap
B.
Burner base
C.
Alignment pins
NOTE: The oval burner base is permanently attached to the
burner cap.
6. Place the burner caps on the appropriate burner bases.
IMPORTANT: The bottom of the small and medium caps are
different. Do not put the wrong size burner cap on the burner
base.
Small cap
(Auxiliary)
7. Turn on the burner. If the burner does not light, check cap
alignment. If the burner still does not light, do not service the
sealed burner yourself. Contact a trained repair specialist.
Surface Grates
The grates must be properly positioned before cooking. In the
proper position, the grates should be flush and level. Improper
installation of the grates may result in chipping or scratching of the
cooktop.
To ensure proper positioning, align the slot left grate with the
center oven vent cover on the cooktop. Repeat with the right
grate. Ensure that the grates are between the locating features in
the cooktop front to back.
B
A
A.
Center oven vent cover
B.
Slots on grate
D. Igniter
E. Gas tube opening
UR
R
Large cap
Large cap
(Semi Rapid)
(Ultra Rapid)
3
Publicité
