Publicité
Les langues disponibles
Les langues disponibles
Vertical model
If the electrical connection box is situated
above the bottom wall bracket, insert the
power cable into the bracket to make
the connection. This way you will prevent
cable pinching.
Horizontal and low models
If the cable is too long, use the cable guide
situated on the wall bracket.
Connection rules
-
The appliance must be connected to a 230 V / 50 Hz single-phase
power supply.
-
The appliance will be connected to the mains by means of the appliance
cable via a connection box.
- Earthing is prohibited. Do not earth the pilot wire
(black wire).
-
There must be a way of disconnecting provided in the fixed pipes,
in line with the installation rules.
- If the power cable is damaged, it must be replaced by the manufacturer,
its After-Sales service or a similarly qualified professional to prevent
any hazards.
- If using the pilot wire, and if it is protected by a 30 mA residual
current device (e.g. bathroom), the pilot wire power supply needs
to be protected on this RCD.
-
If you wish to use a load-shedding device, select one with a pilot
wire output and not with a power output, to avoid damage to the
thermostat.
CONNECTING THE APPLIANCE
CONNECTING THE APPLIANCE
53
EN
Publicité
