EINHELL 4600035 Mode D'emploi page 20

10. Troubleshooting
Danger!
Before troubleshooting, switch off the equipment and pull out the battery.
The table below contains a list of problems and explains what you can do to remedy the problem if your
tool fails to work properly. If the problem persists after working through the list, then please contact your
nearest service workshop.
Problem
Chain saw does not
work at all.
Chain saw operates
intermittently.
Saw chain is dry.
Chain/bar are hot.
Chain saw
juddering, vibrating
or not sawing
properly.
Anl_GE_PS_18_15_Li_BL_NA_SPK7.indb 20 Anl_GE_PS_18_15_Li_BL_NA_SPK7.indb 20
EN
Possible cause
- No power supply.
- Loose connection (external).
- Loose connection (internal).
- On/Off switch defective.
- No oil has been applied.
- No oil on the chain and bar
- Blunt chain.
- Chain tension too loose.
- Blunt chain.
- Worn chain.
- Saw teeth pointing in the wrong
direction.
- 20 -
Solution
- Check the power supply.
- Consult a service center.
- Consult a service center.
- Consult a service center.
- Apply some oil.
- Apply oil.
- Re-sharpen or replace the chain.
- Adjust the chain tension.
- Re-sharpen or replace the chain.
- Replace the chain.
- Reinstall the saw chain with the
teeth facing in the correct direction.
15.11.2023 13:05:01 15.11.2023 13:05:01