Publicité
Les langues disponibles
Les langues disponibles
2 Description
CAUTION!
• This helmet must be stored in a clean, dry area where it is not exposed to extremes of heat or cold which can effect the
helmet's useful service life. Never store a helmet on the back shelf of an automobile; not only will it be exposed to
sunlight (leading to heat and UV damage), but it could become a secondary missile in the event of a sudden stop.
• Clean only with a mild soap and warm water to help avoid skin irritation from wearing the helmet. Even though sample
helmets are proof tested to 2200 V (Class G) and 20,000 V (Class E), the maximum voltage against which the helmet
will protect the wearer depends upon a number of variable factors, such as the characteristics of the electrical circuit, the
care exercised in the maintenance of the helmet and weather conditions. The safe and proper use of the helmet in
electrical applications should be established by the authority having jurisdiction, and their recommendations must be
strictly followed.
Failure to follow these cautions can result in minor or moderate injury.
2
Description
2.1
Helmet Description
The Super V Helmet meets the requirements of CAN/CSA Z94.1-15, Class E, Type II and ANSI/ISEA Z89.1-2014(R2019),
Class E, Type II. This helmet is a system consisting of a shell, suspension, nylon side shield and foam impact liner, which
work together as a unit.
This helmet is designed to provide limited impact and penetration protection to the wearer's head in the event of a top or lateral
blow. It is also designed to provide limited electrical insulation protection.
2.2
Helmet Accessories
Use only MSA supplied or approved accessories with this helmet.
2.3
Adjusting the Suspension
This helmet comes with the suspension installed. It is important to achieve a properly fitted helmet. Follow the instructions in
2.3.1 Fas-Trac® Suspension or2.3.2 1 Touch™
the event of an impact. The suspension straps must lay smooth and flat across the top of the head. The helmet must fit snugly
and maintain its position on the head. The helmet should not bind, slip, fall off or irritate the skin in any way.
WARNING!
If a proper fit cannot be achieved, do not use the helmet.
Failure to follow this warning can result in serious personal injury or death.
2.3.1
Fas-Trac® Suspension
1. Open the Fas-Trac headband by turning the knob to the left.
2. Push the top (inner crown strap toward top of protective helmet. The bottom strap will move in the opposite direction.
3. Place the helmet on head and push down on top of helmet until a comfortable and stable wearing height is reached.
4. Tighten headband by turning knob to the right. Tighten until snug fit is obtained.
NOTE: The headband can be loosened while the helmet is on your head by repeating step 1.
2.3.2
1 Touch™ Suspension
1. Push top crown strap toward crown of helmet; bottom of crown will move in opposite direction.
2. Place helmet on head and push down on top until comfortable wearing height is reached.
SuspensionA helmet that is not properly fitted may not provide protection in
Super V Helmet
US
4
Publicité
