DEFA DSRC50 Mode D'emploi page 4

Please read the manual carefully before use.
Inexperienced users, children aged 8 and above and persons with reduced physical or mental capabilities must only use this product under supervision
or after having read or been given instructions on safe use.
Do not attempt to charge non-rechargeable batteries.
Do not use the Standard or 14,7 charging program on a Li-Ion battery or the Li-ion charging battery on a lead-acid battery.
After use, disconnect the mains power before disconnecting from the battery.
Only use the charger in well-ventilated area and on vented batteries.
This charger must be repaired by professionals.
Never intentionally connect the charger incorrectly, even though it is protected against short-circuiting and reverse polarity.
Do not install the charger in a highly flammable environment.
Do not charge a damaged battery.
• During charging, batteries may release highly explosive gases. Take care not to have sparks, open flames, cigarettes or similar in the vicinity of the
battery and always ensure sufficient ventilation.
• Battery acid is corrosive and harmful. It damages clothes, metal and varnish. In case of spillage and contact with skin, wash and rinse thoroughly with
water and consult a doctor.
• Lead and other chemicals that are used in batteries are toxic. Wash skin and hands thoroughly after working with batteries.
DEFA ShowroomCharger is based on modern switch-mode technology. This charger represent the latest technology within battery charging and
will give the batteries optimal performance and durability. It is well suited to charge lead/acid, AGM, EFB, GEL and lithium-ion batteries up to
approx. 600 Ah for a unlimited time. The charger can be used with up to 45A parallel consumption at the same time as it charges the batteries.
Read the user guide carefully.Please contact DEFA or a qualified person if you are unsure about how to safely use the charger.
2
Connect red clamp to (+) and black clamp to (-) or the connection point recommended by the vehicle manufacturer. The charger is intended for use with
lead/acid, AGM, EFB, GEL and Lithium batteries. The battery manufacturer's recommendations must always be taken into consideration.
Connect the DC charging cable to the charger. See C page 3.
Connect the AC mains cable to the charger. Push the power button once. See B, page 2. The charger will start and initialize the pre-analyze process. To
turn of the charger, push the power button again.
NOTE: To make sure the correct charging voltages are applied, the charging cables must not be shortened or made longer.
4
ABOUT THE CHARGER
3
CONTROL PANEL
No.:
(1)
(1)
(2)
(2)
(3)
(3)
(4)
(5)
(6)
(4)
(5)
(7)
(6)
(8)
(7)
(8)
(9)
(9)
GB
SAFETY
USE
4
Function
Error indicator
Charge level indicator 100%
Charge level indicator 80%
Charge level indicator 60%
Charge level indicator 40%
Charge level indicator 0-20%
Lithium-ion charge program
14,7V charge program
Power button