Publicité
Power Mop Mode
This machine is compatible with BISSELL® bare floor formulas*. Always use genuine
BISSELL formulas in your machine. Other formulas may harm the machine. Scan the
QR code or visit BISSELL.ca for formulas.
1. Remove clean water tank by
2. Fill with hot (140°F/60°C
pressing latch and tilting tank
MAX) tap water to fill line. Do
backward. Open cap on top
not use boiling water. Do not
of tank.
heat water in microwave.
Add cleaning formula to
formula fill line.
4. Press power button to turn
5. Press cleaning mode button
machine on. Recline machine
to switch to Power Mop mode.
to begin cleaning. Return to
Wait 10-15 seconds to allow
upright position to stop.
machine to prime and fully wet
brush roll.
Note: For larger messes and
7. When clean water tank is
area rugs, switch to Turbo
empty, machine will beep and
Mode (A) for additional
display add water icon. If clean
cleaning fluid and suction.
tank is not filled, machine
reverts to dry cleaning mode.
Remove clean tank and refill.
*Compatible BISSELL formulas include: Multi-Surface, PET Multi-Surface with Febreze Freshness,
Simply Multi-Surface Pet, Hard Floor Tough Mess & Odour Eliminator, Hard Floor Sanitize, Wood Floor
Certain trademarks used under license from The Procter & Gamble Company or its affiliates.
3. Close cap. Reinsert bottom
of tank and tilt tank toward
machine until it clicks.
6. For best results, move
machine forward to wet floor
and backward to extract water.
8. If the dirty tank is full,
machine will beep and display
dirty tank full icon. Empty the
tank (pg 8).
CONTINUED ON NEXT PAGE
BISSELL.ca 7
Publicité
