Publicité
Les langues disponibles
Les langues disponibles
IF THESE SOLUTIONS DO NOT SOLVE THE PROBLEM CONTACT YOUR AUTHORIZED SERVICE DEALER.
PROBLEM
Handle not in position.
Snow blower not starting.
The motor is on but the auger does
not turn.
After passing, the snow blower leaves
a layer of snow on the ground.
This product has a Five-year Limited Warranty for personal, family,
or household use (90 days for business or commercial use).
TROUBLESHOOTING
POSSIBLE CAUSE
Upper handle not secured to tubes on
snow blower housing.
Battery is low in charge.
Batteries not in correct orientation
(minimum of one pair).
Start button is not depressed.
The shear pins are damaged or need to
be replaced.
The scraper is worn.
Skid shoes may be set too high.
MAKE THE MOST OF YOUR PURCHASE!
Go to http://register.ryobitools.com and register your new tool on-line.
Your product has been fully tested prior to shipment
For warranty details, visit www.ryobitools.com
or call (toll free) 1-800-525-2579.
to ensure your complete satisfaction.
For any questions about operating or maintaining
your product, call the RYOBI Help Line!
13 — English
SOLUTION
Make sure upper handle is in proper
position and bolts are tightened securely.
Charge the battery.
Confirm battery orientation.
Press start button and auger paddle.
Replace the shear pins. See Replacing
Shear Pins in the Maintenance section.
Replace the scraper. See Adjusting/
Replacing the Scraper in the Mainte-
nance section.
Adjust skid shoes lower to decrease the
gap between the scraper and the ground.
Publicité
