Ryobi RY408015 Manuel D'utilisation page 18

REPLACING SHEAR PINS
See Figures 12 - 13.
Shear pins are located on the auger shaft and below the im-
peller. The pins should be replaced when worn or damaged.
Damaged shear pins may prevent the auger from turning
while the motor is running.
To replace the shear pins:
„ Determine which of the five shear pins is damaged.
„ Using a pair of pliers, remove the damaged shear pin.
„ Locate the replacement shear pins and nuts on the chute
rotation cover.
NOTE: The unit ships with four replacement shear pins.
To order additional shear pins, see the Accessories sec-
tion listed below.
„ Insert the new shear pin into the hole.
NOTE: If necessary, use a rubber mallet to tap the shear
pin into place.
„ Install nut and tighten securely.
ADJUSTING/REPLACING THE SCRAPER OR
SKID SHOES
See Figures 14 - 15.
The scraper may need to be adjusted or replaced when a layer
of snow remains on the ground after making a pass. To order,
call customer service and ask for part number 657780001.
To adjust the position of the scraper and skid shoes:
„ Using a wrench (not included), loosen but do not remove
the bolts that secure the skid shoes to the auger housing.
„ Move the skid shoes up or down to your desired position.
Look for these accessories where you purchased this product or call 1-800-525-2579:
Shear Pins & Nuts ............................................................................................................................................................ACSN01
Skid Shoes.....................................................................................................................................................................ACSN02
MAINTENANCE
NOTE: The scraper is attached to the skid shoes and will
move when the shoes are moved. Position the skid shoes
equally to ensure the scraper is level with the ground.
„ Tighten bolts securely.
To replace the scraper:
„ Remove the bolts and nuts securing the old scraper to
the auger housing and skid shoes.
NOTE: There are three fasteners securing the scraper
to the auger housing and a fastener securing it to each
skid shoe.
„ Discard the old scraper.
„ Place the new scraper inside the auger housing.
„ Reinstall the fasteners to secure the scraper in place.
NOTE: Make sure all fasteners are tightened securely.
Do not overtighten.
To replace the skid shoes:
„ Using a wrench (not included), remove the bolts, nuts,
and washers securing the old skid shoes to the auger
housing.
„ Discard the old skid shoes.
„ Place the new skid shoes to the outside of the auger
housing.
„ Reinstall the fasteners to secure the skid shoes in place.
NOTE: Make sure all fasteners are tightened securely.
Do not overtighten.
REPLACEMENT PARTS
Call customer service at 1-800-525-2579 to request replace-
ment parts.
Left Paddle ........................................................ 549754002
Right Paddle ...................................................... 549754001
Battery Cover. .................................................... 549460001
ACCESSORIES
12 — English