Clarke American Sanders EZ-8 Mode D'emploi page 4

ENGLISH
EN
Operating partially assembled sanding equipment could result in injury to the operator or bystander
DANGER:
and could cause damage to the equipment or to other property.
• Do not operate this equipment unless it it fully assembled and all guards, doors and covers are
secured.
• Keep all fasteners tight.
• Keep all adjustments within manufacturers specifications.
Moving parts on this sanding equipment can cause injury to the operator or bystanders.
DANGER:
• Keep hands, feet and loose clothing away from all moving parts.
• Do not change or adjust the abrasive while the sanding equipment is running.
• Do not service the sanding equipment while it is running.
This sanding equipment requires a supply of electricity. Improper use could result in electrical shock
DANGER:
or fire.
• Connect only to an electrical source matching what is shown on the equipment nameplate.
• Do not use this sanding equipment on an ungrounded electrical circuit. Consult an electrician if
you suspect the circuit is not properly grounded.
• Do not use this sanding equipment with a damaged electrical cord. Inspect before each use.
• Avoid striking the elelctrical cord with the abrasive. Always lift the electrical cord over the sand-
ing equipment.
• Do not use the electrical cord to move the sanding equipment.
• Disconnect the electrical source before servicing this equipment.
In the event of a bag fire, injury can occur to the operator if the operator is tied or strapped to equip-
WARNING:
ment. Use operating belt properly.
Injury to the operator or bystander can occur if protective gear is not worn while sanding. Always use
WARNING:
eye, ear, and respiratory protection while performing any sanding operation.
This sander is not to be used on pressure treated wood. Some pressure treated woods contain ar-
WARNING:
senic and sanding pressure treated wood produces hazardous dust. Inhaling hazardous dust from
pressure treated wood can cause serious injury or death. Sanding pressure treated wood decks or
uneven surfaces can damage the sander which is not covered under warranty or damage waiver.
Bodily injury could occur if power is applied to the equipment with the power switch already in the
WARNING:
"ON" position. Always check to assure that the power switch is in the "OFF" position before connect-
ing power supply.
Maintenance and repairs performed by unauthorized personnel could result in damage or injury.
CAUTION:
Maintenance and repairs performed by unauthorized personnel will void your warranty. Servicing of
this unit must always be referred to an authorized Clarke American Sanders distributor.
Use of this equipment to move other objects or to climb on could result in injury or damage. Do not
CAUTION:
use this equipment as a step or furniture. Do not ride on this equipment.
Damage could occur to the equipment if not properly kept in a dry building for storage.
CAUTION:
equipment in a dry building.
The equipment is heavy. When transporting the equipment, remove the motor. Get help to lift the
CAUTION:
equipment and motor.
Serious damage to the floor can occur if the sanding equipment is left running in one spot while the
CAUTION:
sanding drum is in contact with the floor. To avoid damage to the floor, feather cut in at a normal
sanding rate. Do not dwell while lowering or raising the contact wheel. Always sand at a constant
rate.
-4-
®
Clarke
American Sanders Operator's Manual (EN) - EZ-8 Sander
Store the