5. Visor
• Carefully pull out the pins on the visor from the pin holes on the helmet shell to remo-
ve the visor (Fig. H).
Attention: The pin holes on the helmet can expand through excessive
use. In this case, the visor may no longer be used.
6. Cleaning and care
• All chemicals, paints and stickers can seriously impair the protective effect of the
helmet.
• Only clean your helmet with lukewarm water, mild soap and a soft cloth.
• After every use, leave your helmet exposed to the air in order for it to dry.
7. Disposal
•
Please contact your local waste disposal company for the disposal of the helmet.
Safety information
• The LED rear light is not a substitute for the light equipment stipulated by the German
standard StVZO (§ 67).
• When used correctly, the LED rear light gives better visibility. The LED backlight
should not be used during rainy weather. It cannot be guaranteed to work if it gets
wet.
• Please only use the LED rear light together with this cycle helmet and always put it
onto the rotating wheel of the size-adjustment system.
• The LED rear light is only intended for personal use.
• Please make sure that, during use, the LED cannot be covered or obscured by collars,
rucksacks or movements of the head.
• The LED light can under certain circumstances come loose without this being noticed,
if it becomes caught on jackets, rucksacks or other objects.
• Please be aware that the battery of the LED light can fall out or become flat. Therefo-
re, check the light regularly for proper functioning.
• The batteries must not be exposed to excessive heat such as sunshine, fire or the like.
In the event that the batteries are
LED-rear light SP-07
LED-REAR LIGHT SP-07
7