Armytek BEAR WRG Manuel D'utilisateur page 3

Set description
Flashlight, 21700 Li-Ion 5000 mAh battery, 18650 battery adapter,
magnetic USB charger, nylon holster, lanyard, silicone cone, 2 spare
O-rings, user manual.
The producer reserves the right to change the package at his own
discretion without modifying this manual. Specifications are sub-
ject to change without notice.
Initial Service
TO SET/REPLACE BATTERY
1. Unscrew the tailcap.
2. Place the battery with the positive contact (+) facing the head of
the flashlight.
3. Adjust the tailcap and tighten it as far as it can go.
The flashlight is ready for operation.
HOW TO CONNECT THE MAGNETIC CHARGER
Unscrew the tailcap to 1/4 of a circle and adjust the magnetic charger
to it.
CHARGER COLOR INDICATION
Charger not plugged in:
• Green — device is in waiting mode.
Charger plugged in:
• Green blinking — evaluation of battery voltage.
• Red blinking — unscrew the tailcap to 1/4 for charging.
REV_00-0000
• Orange blinking — USB power source voltage is too low for correct
continuation of charging or bad contact between charger and battery.
Clean the tailcap and the threads of the flashlight parts, use a diffe-
rent power source.
• Red — charging with rated charging current is going on.
• Orange — USB power source voltage is too low, charging current is
reduced.
• Green — charging is finished.
Operation
Before use: Tighten the tailcap as far as it can go.
The flashlight is operated using the side button and the slide switch lo-
cated on the head of the flashlight. The side button turns the flashlight
on/off and switches the modes. The slide switch switches between the
colors of the light.
In OFF state
1 click: To turn on the last used mode of the selected light (except
Beacon mode).
Press and hold: To turn on Firefly mode. Release to select. Keeping
button pressed will start cycling through Main modes.
In ON state
1 click: To turn off the flashlight.
Press and hold: To start cycling through Main modes from any mode:
Main1 - Main2 - Main3. Release to select.
2 clicks: To turn on Beacon mode from any mode. The second double
click brings back last used mode.
SWITCHING BETWEEN THE LIGHT COLORS
The flashlight has three colors of light, which are switched using the
slide switch. The sequence of colors from bottom to top towards the
bezel of the flashlight: white, green, red. The light color can be changed
both when the flashlight is on and when it is off. When the light color
is being changed, the last constant light mode (Firefly or Main mode)
used in this light color is turned on.
If the slide switch becomes jammed or difficult to move, follow the
procedure for cleaning the switch.
Automemorizing. After switching off the last used mode is memorized
for quick access at next switching on.
Lock-out function. Unscrew the tailcap to 1/4 for protection from
accidental switching on. Multicolor indication will be turned off.
Bear WRG USER MANUAL ENG 3