Costway NP11365 Mode D'emploi page 3

Step 2: Raise the Tent
• Unfold the arm joints
located at each of the
tent corners.
Step 3: Lift the Center Hub
• Lift the center hub, and the tent will raise to create tent's cabin
shape, then push down the lower bracket.
Make sure the arm joint on the leg poles are matched in position,
and four leg poles are straight.
04
Bracket
Arm Joint
Step 4: Attached Rainfly
• Drape rainfly over tent, and attach the (4) S hooks to the straps.
Step 5：Stake the Tent, Secure the Wind Ropes
• Drive stakes at a 45º angle through web loop at base of tent to
secure to ground.
• Floor of tent should be taut when staked properly
• Locate wind ropes attached to the rainfly.
• Stake out each wind rope at a 45 degree angle.
• Tighten wind ropes as needed by adjusting the slider up the cord.
TAKE DOWN INSTRUCTION:
To take down the tent, follow the previous steps and illustrations in
the reverse orders:
• Remove all stakes from tent and wind ropes. Store in stake bag.
• Unhook plastic rainfly clips from straps.
• Detach the rainfly, and set aside.
• Pull up the bracket, hold tight roof poles.
S Hook
05