Publicité
Les langues disponibles
Les langues disponibles
GAS CONNECTIONS
GAS CONNECTION - LIQUID PROPANE (LP) CYLINDER
Your Hestan side burner for use with LP gas is supplied with a two-stage regulator/hose assembly
for connection to a standard 20 lb. LP gas cylinder. This assembly must be used WITHOUT
alteration. If this assembly needs to be replaced, contact your Hestan dealer for genuine
replacement P/N 014309.
NOTE: To ensure proper heating performance of this appliance, verify that the supply pressure is
adequate (11.0" WC supply pressure is preferred) to maintain 10.0" WC manifold pressure.
To connect the regulator / hose assembly follow these steps:
1. Locate the regulator and gas connection point in the rear right side of your side burner (in
cart-mounted models, remove the rear panel to gain access).
2. Connect the regulator/hose assembly to the 3/8" Flare (compression flare fitting) X 1/2" NPT
female adapter as shown. Use appropriate thread sealant on all connections.
3. Connect the regulator/hose assembly to a standard 20 lb. LP cylinder. If you plan to
inter-connect the side burner with your Hestan Grill, be sure to use the included fittings
and a flexible hose as short as possible to make the connection. The hose as well as the
connectors must comply with the Standard for Connectors for Outdoor Gas Appliances and
Manufactured Homes, ANSI Z21.75 • CAS 6.27 , and suitable for outdoor installation. Use the
appropriate thread sealant on all connections.
4. Proceed to LEAK TESTING section.
GAS CONNECTION - LP PIPED SYSTEMS
An LP piped system is one with a large central LP tank that feeds an entire household. These
systems are normally equipped with a high pressure regulator by the large LP tank, and low
pressure regulators close to the home. The gas line connectors must comply with the Standard
for Connectors for Outdoor Gas Appliances and Manufactured Homes, ANSI Z21.75 • CAS 6.27 ,
and suitable for outdoor installation. The connection shall be 6 feet (1.82 m) or less.
Please contact Hestan Customer Service to order an LP Piped System Kit for this unique
installation.
NOTE: To ensure proper heating performance of this appliance, verify that the supply pressure is
adequate (11.0" WC supply pressure is preferred) to maintain 10.0" WC manifold pressure.
(continued)
©2016 Hestan Commercial Corporation
EN
17
Publicité
