hestan AGB122 Manuel D'utilisation Et D'entretien page 14

CART INSTALLATION
(continued)
STEP 3
Remove the side shelf by removing the bolt at the rear bracket, and then removing the shelf.
Now you can remove both side shelf brackets from the cart. Replace the large plug with the
EN
grommet as shown.
STEP 4
Remove the rear panel on the cart to access the grill's gas manifold inlet. Disconnect the
regulator and all fittings from the inlet. Install the interplumbing kit as seen below (LP shown).
Use appropriate thread sealant on all connections.
12
©2016 Hestan Commercial Corporation