Publicité
Les langues disponibles
Les langues disponibles
Assembling the product
Drill holes for wall bases
according to the installation distances and
heights of the wall bases
the hole is 12 mm and the depth of the holes
must be the same as that of expansion bolts
The holes of each wall base
same line in transversal direction and vertical di-
rection (fig. A).
Note: It is recommended to draw lines on the
wall first to ensure precise position and size of
the holes.
Take down the original bolts of the wall bases
as shown in figure B, use expansion bolts
to fix the wall bases
make it too tight at the beginning. Just make
the wall bases
2
movement.
Note: the expansion bolts
mered into the wall completely. The bolt must
be stick out of the wall so that the wall base
can be installed on it (fig. C).
Note: the nut and washer might be separated
from the bolt during the process of transporta-
tion, please put them back into their original
positions before hammer them into the wall
during installation.
Make sure all the wall bases
same horizontal line.
Install the awning on the wall bases
ing to „Notes for drilling", put the original bolts
on the wall bases
fasten all the expansion bolts
Troubleshooting
Leveling the front side:
1. Loosen the locking nuts
2. Turn the jack bolt
3. Adjust the arm
C
horizontal line.
4. Tighten the locking nuts
12 GB/IE
on the wall
2
. The diameter of
2
must be on the
2
on the wall. Don't
2
stay on the wall with a little
must be ham-
11
are on the
2
accord-
2
and tighten them. Finally
2
(fig. D).
11
.
A
to adjust pitch.
B
until the front side stays in
.
A
.
11
C
Initial use
Use the crank handle
2
fully, then close it completely to test for proper
11
operation.
Use the crank handle
to desired extension.
2
10
Open
Close
Cleaning and care
Allow all the parts to dry thoroughly before
you put the product away again. This will pre-
vent the formation of moulds, odours and dis-
colouration.
Clean the product with a slightly dampened,
lint-free cloth.
Always keep the product dry and clean at
room temperature.
Disposal
The packaging is made entirely of recyclable mate-
rials, which you may dispose of at local recycling
facilities.
Contact your local refuse disposal authority for
more details of how to dispose of your worn-out
product.
A
B
to open the awning
10
and open the awning
10
Publicité
